DISERTASI dan TESIS Program Pascasarjana UM, 2016

Ukuran Huruf:  Kecil  Sedang  Besar

Pengembangan Modul dan Trainer PLC Mikro Berbasis Kompetensi pada Pembelajaran Mekatronika

Agus Suyetno

Abstrak


ABSTRACT

 

Suyetno, Agus. 2016.

The Development of Module and PLC Micro Trainer Based

on Mechatronic Competency Training. Thesis. Vocational Education,

Graduate Program, State University of Malang. Advisors: (I) Prof. Dr. Ir.

H. Djoko Kustono, M.Pd, (II) Dr. Dwi Agus Sudjimat, S.T., M.Pd.           

Keywords: module, PLC Micro trainer, mechatronics competence.

Mechatronics is one of the compulsory subjects taken by students

Department of Mechanical Engineering, State University of Malang because it is

closely connected with the control system in the industry. Problems that hamper

the attainment of mechatronic by need analysis include: 1) lack of practicum

proposition; 2) learning resources are limited; and 3) there is no job sheet of

practicum. The solution used from the front end analysis. The purpose of this

research and development are 1) to develop trainer PLC and also can be simulated

on a computer, 2) develop modules, and 3) develop job sheet as a learning

resource mechatronics training.

This research is a research and development with ADDIE development

model that comprises the step of analysis, design, development, implementation,

and evaluation. In the analysis phase will be performed need analysis and frontend

analysis. At the stage of development, will be carried out expert validation

and user validation. In the implementation phase, formative evaluation will be

conducted. Whereas summative evaluation at this stage of the evaluation was not

done because of the research that will be done only at the stage looking at the

feasibility of the media developed.

The results of the validation experts during the development stage, the

developed media included in the rate valid and suitable to use (96.36%). Based on

the user validation results, developed media included in the rate valid and suitable

to use (90.00%). At stage of individual testing, obtained the average results of

student test is 86 and the results of questionnaires students' perceptions on the

media is a suitable to use (87.62%). At the pilot phase a small group, obtained the

average results of student test is 86 and the results of questionnaires students'

perceptions on the media is a suitable to use (91.43%). At stage of field trials,

obtained the average results of student test is 87 and the results of questionnaires

students' perceptions on the media is a suitable to use (83.67%). For further

development, the media can be developed to run through a smart phone because

the media are being developed can only be run on a computer. Besides that, to the

 

further development can also use Arduino to use the Micro PLC trainer.